I/O Wiring - Omron K6CM User Manual

5 Installation and Wiring
5-5

I/O wiring

This section describes input/output wiring, power supply wiring, external trigger input wiring and transis-
tor output wiring of the K6CM devices.
Wiring Diagram of the Vibration & Temperature Type (K6CM-VB)
fuse
Single phase
power supply
PLC etc.
Measurement trigger signal.
Computer,
PLC etc.
LAN
Note When you use an inverter to drive the motor, you may not be able to check the degradation tendency of the
motor. However, under the following conditions, it is comparatively easier to check changes in acceleration.
• The inverter driving frequency is 50 Hz or more and the frequency is stable.
• The carrier frequency of the inverter is 12.5 kHz or more and the frequency is stable.
Use the device after testing in a similar environment as the installation environment during use.
5 - 20
Red and White
1 7
Red
2 8
Black
3 9
Black and White
4
10
DO NOT USE
DO NOT USE
K6CM-VBM
13
14
15
16
EtherNet/IP 17
LAN
18
VBS0
VBS1
K6CM-VBS
VBS2
(Pre-amplifier)
VBS3
PLC etc.
Transistor Output
Transistor Output
PLC etc.
Transistor Output
PLC etc.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Monitor target
(motor etc.)
Connector