7 Motor Monitoring with the K6CM Devices and the Software Tool
2
When the trigger mode is "Always (while power is ON)", measuring and monitoring will be
started.
Measured value is displayed on the numeric display LCD on the front of the device. At the same
time, "MON" of the state display on the front of the device gets lit.
• When the trigger mode is "external trigger", operate the external input.
• When the trigger mode is "internal trigger", wait until the state of the measured value
becomes the start condition of measuring and monitoring.
3
When measurement and monitoring are started after the power is turned ON, the numeric dis-
play LCD in the front of the device switches from "- - - -" to the measured value display. At the
same time, "MON" of the state display on the front of the device gets lit.
Numeric LCD display
Changes from "- - - -" to the
measurement value display.
Status display
"MON": Measurement and
*1. In the factory default, "PV" is lit as the type of measurement such as present value, minimum value, and max-
imum value. The numerical display shows "present value". When "Display value selection" is set to "minimum
value" or "maximum value" with the software tool or EtherNet/IP, "MAX" or "MIN" is lit as the type of measure-
ment such as present value, minimum value, and maximum value, and the numerical display shows "mini-
mum value" or "maximum value".
7 - 4
*1
monitoring in progress
Unit of measurement value
(Measurement type)
Types of measurement such as
current value, minimum value,
and maximum value.
K6CM Motor Condition Monitoring Device User's Manual (N219)
*1