Omron K6CM User Manual page 232

Appendices
Other Setting Values
Common to the K6CM Devices
Data name
Sets the IP address of the K6CM.
K6CM IP
address
The initial value is "192.168.250.10" (common to models)
Restarts the K6CM device. It is used to validate the setting
Software
after changing the setting value.
reset
Rising from 0 to 1: Execute (soft reset)
Initializes the MAX / MIN value.
Max./min.
reset
OFF to ON: Execute (initialize max. and min. value)
Sets which measured value is displayed in the 7 segment dis-
play of the K6CM.
0: PV
1: MIN
Display
2: MAX
value type
To see which measured value is displayed, you can check with
the monitoring category display on the K6CM.
"PV": present value, "MIN": minimum value, "MAX": maximum
value
Selects either internal trigger, external trigger, constant mea-
suring and monitoring (no trigger).
Trigger
0: Always
mode
1: External trigger
2: Internal trigger
For internal trigger or external trigger, select either rising, fall-
ing, or level.
0: Rising
1: Falling edge
2: Level
• For internal trigger:
Rise: When the measured value exceeds the set value (trig-
ger level)
Falling edge: When the measured value falls below the set
Trigger type
value (trigger level)
Level: During the measured value exceeds the setting value
(*1)
*1. In the case of "Insulation resistance" for the lower limit
• For external trigger:
Rise: When external input changes from OFF to ON
Falling edge: When external input changes from ON to OFF
Level: External input is in the ON state
A - 16
Description
alarm, it oppositely means "lower" than the setting value.
Writing method (Yes: supported, No: sup-
Software
tool
Yes
Yes (Soft-
ware reset
button)
Yes
(Reset the
maximum
and mini-
mum value
button)
Yes
Yes
Yes
K6CM Motor Condition Monitoring Device User's Manual (N219)
ported)
CIP mes-
sage com- Tag data link
munications
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No