Omron K6CM User Manual page 95

Procedure for Setting IP Address (when necessary, further parame-
ters)
The IP address of each K6CM device is set by the following procedure. It is also possible to set further
parameters when necessary.
The initial value of the IP address of the K6CM device is "192.168.250.10" common to all models.
1
Connect your PC directly to the K6CM device cone-on-one using the Ethernet cable.
2
Start the Motor condition monitoring tool.
The following startup screen will be displayed.
3
Select [Device setting].
The following SYSMAC Gateway Console screen is displayed.
(1) Confirm that [Startup] in the [Communication Service] field is "Auto" and that [Status] is
"Start".
Note The communication service of SYSMAC Gateway is in the starting state at the same time that
(2) Set the network port to which you want to connect in the [Network Port] field.
Note If you set multiple ports, the port with the smallest ID number in the [Port ID] column is auto-
K6CM Motor Condition Monitoring Device User's Manual (N219)
Windows starts, when [Startup] on the SYSMAC Gateway Console screen is "Auto".
matically used.
4 Introduction of the Software Tool
4
4 - 29