Ip Address Setting Of The K6Cm Devices - Omron K6CM User Manual

4-3-2

IP Address Setting of the K6CM Devices

There are two ways to connect the software tool to the K6CM.
• Automatic connection (direct one-to-one connection)
• Fixed IP Connection (connection via hub)
Automatic connection (direct one-to-one connection)
Directly connect the computer and each K6CM device via the Ethernet cable without going through the
hub.
In the case of direct connection, there are the following merits:
• Can be connected without specifying IP address of K6CM device.
Either straight type or cross type Ethernet cable is available.
Note If the IP address setting method of the K6CM device is set to BOOTP, auto connection can not be made
until connecting to the BOOTP server.
Create the project
IP address setting
K6CM Motor Condition Monitoring Device User's Manual (N219)
Parameter setting (as necessary)
100 to 240 VAC or
24 V power supply (by type)
EtherNet/IP port
Software tool
Ethernet cable
(Straight or cross)
4 Introduction of the Software Tool
Motor condition monitoring
equipment
K6CM device
4
4 - 27