Omron K6CM User Manual page 150

6 How to Use the Software Tool
• [Device setting] Button
Change the IP address of the device.
IP address, subnet mask, default gateway.
• [Monitoring setting] Button
Change the monitoring cycle.
Can be set in the range of 5 to 99999 seconds. (The initial value is 600 seconds.)
The monitoring cycle is the cycle at which the software tool collects measured values from
the K6CM devices.
The measured values are collected by the software tool at that cycle, regardless of the
K6CM device state such as the use of trigger or the determination of measured value.
Precautions for Correct Use
If the monitoring cycle is too short, depending on the performance of your PC, the operation of
the software tool may be delayed and may not operate at the set monitoring cycle.
Set the monitoring cycle according to the performance of your PC. Also, if the size of the log file
increases, depending on the performance of your computer, the operation of the software tool
may be delayed. In that case, periodically save the log files and move them to another lloca-
tions.
6 - 20
K6CM Motor Condition Monitoring Device User's Manual (N219)