Omron K6CM User Manual page 254

Appendices
3
Creating Network Variables (Input)
Create network variables to be the input area in the PLC.
The K6CM device sends 44 bytes as Input data, therefore the network variable must be created
as a structure variable or an array variable.
This section shows how to create structure variables. (For array variables, the following "(1)
data type registration" are unnecessary.)
(1) Registering Data Type
Create a structure type as a basis by the following procedure to create a structure type net-
work variable (44 bytes) for receiving K6CM's Input data.
(1)-1 Opening the Data Types Tab Page
Double-click [Data Type] under [Programming] | [Data] in the Multiview Explorer, or
right-click [Data Type] and select [Edit] from the menu.
(1)-2 Registrating structure Type
Click the [Structures] Side Tab in the Data Type Editor, and then the Structure Data Type
Editor is displayed.
In the Data Type Editor, press the [Insert] key or right-click and select [Create New Data
Type (N)], and enter a structure name. As an example, we set "t_K6CM_CIM" here. An
error is displayed because there is no structure member registration at this time.
A - 38
K6CM Motor Condition Monitoring Device User's Manual (N219)