Profile Alarmvdsl Show Command - ZyXEL Communications MSC1000G User Manual

26.7.1 profile alarmvdsl show Command

Syntax:
profile alarmvdsl show [<profile>]
where
<profile>
This command displays the details of the specified alarm VDSL profile or lists all of the alarm
VDSL profiles if you do not specify one.
The following example displays the default alarm VDSL profile (DEFVAL).
ras> profile alarmvdsl show DEFVAL
vdsl alarm profile : DEFVAL
initFailure(ift)
15MinLofs(lofs)
15MinLoss(loss)
15MinLols(lols)
15MinLprs(lprs)
15MinESs(ess)
15MinSesL(sesl)
15MinUasL(uasl)
ras>
26.7.2 profile alarmvdsl set Command
Syntax:
profile alarmadsl set <profile> [lofs <lofs>] [loss <loss>] [lols <lols>]
[lprs <lprs>] [ess <ess>] [sesl <sesl>] [uasl <uasl>] [ift <ift>]
where
<profile>
<lofs>
<loss>
<lols>
<lprs>
<ess>
Chapter 26 profile Commands
= The name of an alarm profile.
:
(sec):
(sec):
(sec):
(sec):
(sec):
(sec):
(sec):
= A name for the alarm profile (up to 31 ASCII characters).
= The number of Loss Of Frame Seconds (0~900) that are
permitted to occur within 15 minutes.
= The number of Loss Of Signal Seconds (0~900) that are
permitted to occur within 15 minutes.
= The number of Loss Of Link Seconds (0~900) that are
permitted to occur within 15 minutes.
= The Number of Loss of PoweR seconds (0~900) permitted to
occur (on the ATUR) within 15 minutes.
= The number of Errored SecondS (0~900) that are permitted to
occur within 15 minutes.
MSC1000G User's Guide
-
0
0
0
0
0
0
0
415