Vdsl-Profile Commands; Table 85 Vdsl-Profile Commands - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

Chapter 32 Introducing the Commands
Table 84 vdsl-alarmprofile Commands (continued)
COMMAND

32.11.7 vdsl-profile Commands

The following table lists the

Table 85 vdsl-profile Commands

COMMAND
vdsl-profile
<name>
applicablestandard <2>
bandplan <2>
compatiblemode <1..4>
deployment <1..2>
exit
hamband
interleavedelay
238
15minsLoss
<threshold>
15minsSESs
<threshold>
exit
initFailure
<on|off>
vdsl-profile
DESCRIPTION
Sets the number of Lost of Signal
(Los) errors allowed in any 15-minute
period. An alarm is triggered if this
number is exceeded.
Sets the number of Severely Errored
Seconds(SES) errors allowed in any
15-minute period. An alarm is
triggered if this number is exceeded.
Exits from this command mode.
Sets whether the device is to send an
initialization failure trap or not.
commands in configuration mode.
DESCRIPTION
Enters VDSL profile command
mode.
Sets a standard your switch uses
for VDSL services.
2: ETSI
Sets a VDSL band plan to use for
the line.
2: Bandplan998
Sets the starting band of the
frequency range used by VDSL
services.
1: none
2: 640kHz
3: 1100kHz
4: 2200kHz
Specify a VDSL deployment
scenario.
1: FTTCab
2: FTTEx
Exits from the VDSL profile
mode.
Sets the device not to transmit
mask
signals in the pre-defined HAM
<00000000000..00
(Handheld Amateur Radio) radio
000111100>
band(s).
Specify maximum interleave
ds <0..255>
delay for downstream traffic in
the slow channel.
Specify maximum interleave
us <0..255>
delay for upstream traffic in the
slow channel.
VES-1616F-3x Series User's Guide
P
13
13
13
13
P
13
13
13
13
13
13
13
13
13