Chapter 3 Setting Programmable Controller Local Station; Communication Settings; Refresh Settings - Mitsubishi Electric MELSEC iQ-F Series Quick Start Manual

3
SETTING PROGRAMMABLE CONTROLLER
LOCAL STATION
This chapter describes the settings for the programmable controller local station in the system.
3.1

Communication Settings

For the communication setting procedure, refer to Page 23 Setting Parameters, Step 4.
Setting item
Station Type
Network No.
Station No./IP Address Setting Method
Station No.
IP Address
Subnet Mask
*1 Refer to the system configuration (Page 9 System Configuration).
3.2

Refresh Settings

This section describes the refresh settings for the local station by referring to Section 2.3 Refresh Setting. (Page 14
Refresh Settings)
For the refresh setting procedure, refer to Page 23 Setting Parameters, Step 6.
Assignment target device on the programmable controller side
Y1000 to Y1017
X1000 to X1017
D100 to D115
D200 to D215
3 SETTING PROGRAMMABLE CONTROLLER LOCAL STATION
22
3.1 Communication Settings
Initial value Setting range
Local Station Master Station, Local Station
1 1 to 239
Parameter Editor Parameter Editor (fixed)
1 Master station: 0 (fixed)
Local station: 1 to 120
Master station: 0.0.0.1 to 223.255.255.254
192.168.3.249
Local station:
192.168.3.11
255.255.255.0 0.0.0.1 to 255.255.255.255
Setting value
Local Station
1
Parameter Editor (fixed)
*1
2
192.168.3.11
255.255.255.0
Point Link device
16 RY20 to RY2F
16 RX20 to RX2F
16 RWw4 to RWw13
16 RWr4 to RWr13
*1
*1