Program Example (Parameter Setting Example) - Mitsubishi Electric MELSEC-Q Series User Manual

9.8.1

Program example (parameter setting example)

This section shows an example of configuring settings for a master/local module in the following system configuration.
Station number 1
Local station
(occupies 1 station)
1.
Create a project on a programming tool.
Select "QCPU (Q mode)" under "Series". Select "Q20UDH" under "Type".
[Project]
Model name
Q20UDHCPU QJ61BT11N
Start I/O number X/Y100 to X/Y11F
Remote I/O station
(Error invalid station)
(occupies 1 station)
[New]
CHAPTER 9 DEDICATED INSTRUCTIONS
Master station
Terminating resistor
Station number 2
Terminating
resistor
Station number 3
Remote I/O station
(Reserved station)
(occupies 1 station)
213
9