Network Operation Settings - Mitsubishi Electric MELSEC-Q Series User Manual

7.5 Network Operation Settings

Set operating status of a network if a data link error occurs or the CPU module is set to STOP.
Item
Enter the name of network operation setting
Parameter Name
parameters if desired.
Select whether to hold or clear data input from the
Data Link Faulty Station
slave station No.17 to 120 where a data link error has
Setting
occurred. (Refer to Section 8.3.5.)
Select whether to hold or clear cyclic data output by
Output Setting During the station No.17 to 120 when the CPU module
CPU STOP mounted with the Simple Motion module is set to
STOP. (Refer to Section 8.3.6.)
(Note-1): The range from the station No.1 to 4 is valid in the 4-axis module, and the range from the station No.1 to 8 is valid in the 8-axis
module.
1) Set network setting parameters. (Refer to Section 7.3.)
2) Open the setting window.
Project window
[Ethernet/CC IE/MELSECNET]
3) Set parameters in the window.
Description
[Parameter] [Network Parameter]
[Network Operation Settings] button
Up to 8 characters
• Turn OFF or 0 Clear Input Data
(RX/RY)
• Hold Input Data
(Default: Turn OFF or 0 Clear Input
Data (RX/RY))
• Hold
• Clear (ALL OFF)
(Default: Hold)
7 - 20
Chapter 7 PARAMETER SETTING
Setting range Remark
–
All invalid for the
station No.1 to 16
(Note-1)
.
All invalid for the
station No.1 to 16
(Note-1)
.