Cable The Library Task 2: Connect Cables To The Drive Assembly And Power Supply; Cable The Library Task 3: Connect The Network Port; Module Controller Ports (Output Port Shown With Dust Cover); Initial Cabling - StorageTek SL150 Manual

Cable the Library
Figure 2–27 Module Controller Ports (Output port shown with dust cover)

Cable the Library Task 2: Connect Cables to the Drive Assembly and Power Supply

For each power supply, connect the power cord to power supply and the power
1.
distribution unit in the rack.
For each installed tape drive, connect the interface cable(s) to the tape drive
2.
interface port(s). Attach a label indicating the tape drive position in the module
and port to ensure proper connection after a service action.
Figure 2–28 Initial Cabling
Illustration Legend:
1 - Tape Drive Fibre Channel Cable
2 - Expansion Cable
3 - Ethernet Cable (Net Mgt Port 1)
4 - Power Supply Cord
5 - Tape Drive Serial Attached SCSI (SAS) Cable

Cable the Library Task 3: Connect the Network Port

Locate the NET MGT area of the base module (above the power supply and left of
1.
the Module Output ports).
Insert the Ethernet cable plug in the top port, designated with a 1 on the chassis.
2.
2-28 StorageTek SL150 Modular Tape Library Guide
The interface port is located on the left side of the drive tray
Note:
assembly (as viewed from the rear of the library).