Table of Contents
Advertisement
Table 7-2
recommended actions. Refer to
display locations on the standard and CSL operator panels.
The notation "xxxx" is a four-character hexadecimal fault symptom code (FSC).
Note: Refer to
Table 7-2. Error Displays and Instructions
Display
Probable Cause
A steady asterisk (*) indicates
*
that the drive completed IPL,
and is online but not loaded.
An asterisk (*) alternating
*
with Offline indicates that
Offline
drive or CSL is offline.
This is the normal display
ASIA DIAGS
during IPL.
During a boot, a section of
Bank n Bad
memory (n=1, 2, 3, or 4) is
found bad.
The IPL failed.
Boot Fail
A sequence of switches took
BT Monitor
you to an Engineering zone.
Rebuild of tape Media
BldMIRFail
Information Region (MIR)
unsuccessful.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx.
The hardware revision level
cnhndnsn
supported by the firmware in
this drive, where:
n=any number 0–9,
c=controller processor level
h=host side formatter level
d=device side formatter level
s=servo level.
This is the normal display
CC DIAG
during IPL.
95741
provides an alphabetical list of operator panel error displays and
"Error and Recovery" in Chapter 5, "Cartridge Scratch Loader,"
for additional errors for the CSL.
Sixth Edition
Figure 7-1 on page 7-1
Recommended Action
Operator discretion.
Operator discretion.
Place drive Online for use by the host.
Wait for IPL to complete.
If IPL does not correct the problem, replace
the drive or CSL.
Initiate IPL again.
If IPL fails again, replace the drive or CSL.
IPL the drive or CSL to clear the error.
This message occurs when the firmware
level is insufficient to control the hardware
level in the drive.
Install newer firmware level.
Wait for the IPL to complete.
Dislodge a Stuck Tape
for switch, indicator, and
7-3
Advertisement
Table of Contents
