Mitsubishi Electric QJ81DL96 User Manual page 94

3
SPECIFICATIONS
3.4 Buffer Memory List
The following table shows the buffer memory list.
Address (Decimal)
10000 to 14095
3.4.1 Module status area (address: 0 to 20)
The status of the high speed data logger module can be checked in this area.
Decimal address
(Hexadecimal)
0 (0 ) RUN LED status
H
1 (1 ) ERR. LED status
H
2 (2 ) CF LED status
H
3 (3 ) Switch 1 status
H
4 (4 ) Switch 2 status
H
5 (5 ) Switch 3 status
H
6 (6 ) Switch 4 status
H
20 (14 ) Module operating status
H
3
- 24 3.4 Buffer Memory List
3.4.1 Module status area (address: 0 to 20)
0 to 20 Module status area
21 to 25 CompactFlash card information area
47 to 64 Network connection status area
70 to 80 Common setting status area
100 to 109 Time synchronization information area
140 to 145 Current error area
150 to 247 Error log area
800 to 805 General data sampling delay time area
810 to 841 Recipe file area
1500 to 1593 Access target CPU setting status area
2000 to 2989 Data logging status area
3000 to 3989 Event logging status area
4000 to 4989 Report creation status area
5000 to 5992 E-mail transmission status area
6000 to 6001 FTP server status area
6002 to 7457 FTP client status (PUT) area
7999 FTP client setting area
Event logging area
POINT
(1) Addresses not listed in the table above are areas used by the system.
Do not use these areas as there is a risk of malfunction when writing to them.
(2) The values stored in the buffer memory are cleared when the programmable
controller is powered ON from OFF, or the programmable controller CPU is
reset.
Name
Application
Description
0: OFF 1: ON 2: Flashing
0: OFF 1: ON 2: Flashing
0: OFF 1: ON 2: Flashing
b0 to 1: 0: Online 1: H/W test
2: Self-loopback test
b0: ON: Account default setting
b1: ON: Connection default setting
15 to 255 (seconds): Response monitoring time
b0: ON: Operates when the file switching timing of the
module whose first five digits are '11101' or lower
0: Initializing 1: Running 2: Stopping 3: Stopped
Reference
Section 3.4.1
Section 3.4.2
Section 3.4.3
Section 3.4.4
Section 3.4.5
Section 3.4.6
Section 3.4.7
Section 3.4.8
Section 3.4.9
Section 3.4.10
Section 3.4.11
Section 3.4.12
Section 3.4.13
Section 3.4.14
Section 3.4.15
Section 3.4.16
Section 3.4.17
Section 3.4.18
R/W
R
R
R
R
R
R
R
R
R: Read-only
Initial
value
0
0
0
0
0
0
0
0