Mitsubishi Electric QJ81DL96 User Manual page 576

18
TROUBLESHOOTING
Error code
00F0
H
Link error
Special module bus error
00F1
H
00F2 Special module timeout
H
0100
H
to
0104 System error
H
0110
H
0112
H
0180 Switch setting error
H
0181 ROM check sum error
H
0182 RAM test error
H
0190 Timeout error
H
0191 Communication error
H
0192 Comparison error
H
0193 In-frame position error
H
0200
H
to
0203
System error
H
0210
H
0300
H
DHCP parameter
0304
H
acquisition error
0305
H
to System error
0308
H
DHCP lease renewal
0319
H
failure
031A Network diagnostics error
H
0330
H
0400
H
System error
to
0402
H
0480
H
CompactFlash card mount
to
failed
0483
H
0490
H
to System error
0493
H
18
- 9 18.2 Error Code List
Error name
A request was made to a link stop station.
The specified intelligent function module is
not ready for processing.
No response has been received from the
specified intelligent function module.
A switch setting error was detected in the
hardware test.
A ROM error was detected in the
hardware test.
A RAM error was detected in the hardware
test.
An error occurred in the self-loopback test.
When set to automatically acquire an IP
address in the LAN connection, failed to
acquire the network parameter information
from the DHCP server.
The automatic lease renewal process,
which occurs when the IP address lease
acquired from the DHCP server expires,
failed.
Network diagnostics (ping transmission)
failed.
The CompactFlash card mount is failed
because a failure was detected.
Description
-
-
-
-
-
(From the previous page)
Action
• Restore the link to connect the station
on the access route.
• Examine the hardware of the intelligent
function module.
• Please consult your local Mitsubishi
representative, explaining a detailed
description of the problem.
• Check the intelligent function switch
setting.
• Perform the hardware test again.
• Perform the hardware test again.
• Hardware error
• Please consult your local Mitsubishi
representative, explaining a detailed
description of the problem.
• Please consult your local Mitsubishi
representative, explaining a detailed
description of the problem.
• Check the connection status with the
DHCP server.
• Check the connection cable.
• Check the DHCP server settings.
• Please consult your local Mitsubishi
representative, explaining a detailed
description of the problem.
• Check the connection cable and status
of the DHCP server (start status,
secured allocated IP addresses).
• Check the connection cable, status of
the external device.
• Check if the destination for the network
diagnostics setting in "Network setting"
is correct.
• Please consult your local Mitsubishi
representative, explaining a detailed
description of the problem.
• Check if the CompactFlash card was
inserted properly.
• Replace the CompactFlash card.
• Please consult your local Mitsubishi
representative, explaining a detailed
description of the problem.
(Continued on the next page)