Mitsubishi Electric QJ81DL96 User Manual page 160

4
SETTINGS AND PROCEDURES UP TO OPERATION
Switch 1
Switch 2
Switch 3 (lower byte)
Switch 4
Switch 5
(1) Mode setting (Switch 1)
(2) Default operation setting (Switch 2)
b15 b14 b13 b12 b11
Specify 0.*1
*1: If this area is other than 0, the switch setting error (0180H) occurs during
hardware testing.
*2: You can specify 1 only for the modules whose first 5 digits of the serial
number are "13092" or higher. Specify 0 for the other modules.
*3: You can specify 1 only for the modules whose first 5 digits of the serial
number are "17092" or higher. Specify 0 for the other modules.
4
- 15 4.5 Intelligent Function Module Switch Setting
 Configure switches with the "Switch setting for I/O and intelligent function module"
setting.
Configure switch 1 to 4 shown in the table below.
They can be easily entered by switching the input format.
After configuring, click the
Switch number
Mode setting
Default operation setting
Response monitoring time setting
Compatibility setting
System use (do not set)
Select the high speed data logger module operation mode.
Setting
Item
number
0000 Online
H
0001 Hardware test
H
0002 Self-loopback test
H
Set to temporarily operate the module with the default settings for the account setting
and network setting. Moreover, set the port number and destination directory of the
FTP transfer function.
For details of FTP transfer, refer to the following section.
Section 3.4.17 (1) FTP transfer port number (address: 7999)
Appendix 11 FTP Transfer Directory Configuration
to
Specify 0.*1
FTP transfer directory*2
0: Same as the directory configuration of
CompactFlash card
1: Fixed directory
FTP transfer port number setting*3
0: Access port 21
1: Access to the port set in the buffer memory
(FTP transfer port number)
button.
Description
Description
The normal operation mode.
Performs a test of ROM/RAM/switch settings.
Performs a self-diagnostics test of the 10BASE-T/
100BASE-TX interface.
b2 b1 b0
Switch 2
Default operation setting (account setting)
0: Operates with the account settings
1: Operates with the default settings
Does not use the access
authentication function.
Default operation setting (network setting)
0: Operates with the network settings
1: Operates with the default settings
IP address
Subnet mask
Does not execute network diagnostics
(ping).
Connects to network when the module
is activated.
Reference
(1) in this section
(2) in this section
(3) in this section
(4) in this section
-
Reference
-
Section 4.6.2
Section 4.6.1
: 192. 168. 3. 3
: 255. 255. 255. 0