To do...
Specify a router ID
Enter interface view
Enable an OSPFv3 process on the
interface
Configuring OSPFv3 area parameters
The stub area and virtual link features of OSPFv3 are the same as OSPFv2.
Splitting an OSPFv3 AS into multiple areas reduces the number of LSAs and extends OSPFv3
applications. For those non-backbone areas residing on the AS boundary, configure them as stub areas
to further reduce the size of routing tables and the number of LSAs.
Non-backbone areas exchange routing information through the backbone area. The backbone and
non-backbone areas—including the backbone itself—must be contiguous. In practice, necessary
physical links may not be available for this connectivity. You can configure virtual links to address the
problem.
Configuration prerequisites
Before configuring OSPFv3 area parameters, complete the following tasks:
Enable IPv6 packet forwarding
•
Configure OSPFv3 basic functions
•
Configuring an OSPFv3 stub area
Follow these steps to configure an OSPFv3 stub area:
To do...
Enter system view
Enter OSPFv3 view
Enter OSPFv3 area view
Configure the area as a stub area
Specify a cost for the default route
advertised to the stub area
Use the command...
router-id router-id
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
Use the command...
system-view
ospfv3 [ process-id ]
area area-id
stub [ no-summary ]
default-cost value
284
Remarks
Required
—
Required
Not enabled by default
Remarks
—
—
—
Required
Not configured by default
Optional
Defaults to 1