Table of Contents
Advertisement
LED Mode Select Button and Indicator LEDs
To optimize the amount of information that can be displayed for each of the
switch ports, the Series 5300xl Switches use a Mode LED for each port. The
operation of this LED is controlled by the LED Mode Select button on the
switch chassis, and the current selection is indicated by the mode indicator
LEDs near the button. Press the button to change from one mode to the next.
LED Mode Select button
and indicator LEDs
Status
1
2
A
B
C
D
an
Power
Modules
Act
If the Activity
indicator LED is lit, each port Mode LED displays
activity information for the port—it flickers as network traffic is received
and transmitted through the port.
If the Full Duplex
those ports that are operating in full duplex.
If the maximum speed
for those ports that are operating at their maximum possible link speed,
for example 1000 Mbps on a 100/1000-T port.
!
If the attention
each network event that might require operator attention, for example,
late collisions or CRC errors. See chapter 4, "Troubleshooting" for more
information.
Introducing the HP ProCurve Series 5300xl Switches
!
Act
FDx
Max
LED Mode Select
FDx
indicator LED is lit, the port Mode LEDs light for
Max
indicator LED is lit, the port Mode LEDs light
indicator LED is lit, each Mode LED lights briefly for
Front of the Switch
Mode LEDs
(one for each port)
Use xl modules only
A
procurve
xl
xl module
J4820A
C
1-7
Advertisement
Table of Contents
