Accessing The Ctp2000 Platform; Setting Up Management Access On The Ctp2000 Platform - Juniper CTP2000 Series Hardware Documentation

CHAPTER 17

Accessing the CTP2000 Platform

Setting Up Management Access on the CTP2000 Platform

Copyright © 2017, Juniper Networks, Inc.
Setting Up Management Access on the CTP2000 Platform on page 111
CTP2000 Console Port Setup on page 112
Using HyperTerminal with the CTP2000 Platform on page 113
Connecting Directly to the CTP2000 Platform on page 113
CTP2000 Platform SSH Setup on page 114
Before you power on the device, you must set up a management console. You use the
console to communicate with the device during the power-on process, to set an IP
address, and to manage the system using the command-line interface (CLI).
You can monitor and manage the system through either of these methods:
Console terminal—You can connect a console terminal (PC, Macintosh, or UNIX
workstation) directly to the
directly to the device, you can configure the device without an IP address. To
communicate with the device, you must have a terminal emulation program running
on your PC or Macintosh. You can use any terminal emulation program, such as
HyperTerminal. A UNIX workstation can use the emulator TIP.
You can connect a console to the COM2 port on the PP310 and PP332 processors. On
the PP833 processor, a console is connected using the supplied USB-to-DB9 cable
(p/n 720-071594), in which the DB-9 connector has the same pinout as a standard
RS-232 DTE port. When the USB-to-DB9 cable is used in conjunction with the DB-9
adapter labelled "p/n 450-071855", the available RJ-45 console pinout will be the
same as the console connection on the RTM of PP332/PP310 processor.
Alternatively, if the DB-9 adapter from the bag labelled "p/n 720-056657" is used
instead of "p/n 450-071855", the available RJ-45 console pinout will be similar to the
CTP150 console port (and other Juniper routers). To connect the PP833 processor
with the DB-9 male serial port of a PC, additionally connect a straight RJ-45 cable with
the DB-9 adapter from the bag labelled "p/n 720-056657". The other end of the RJ-45
cable connects to the DB-9 adapter from the bag labelled "p/n 720-014126". Then,
you can connect the PC's DB-9 male connector with the DB-9 adapter "p/n 720-014126".
CONSOLE terminal port. When you connect a console
111