Removal Of Driven Pulley Assy - TGB Hornet 50 Service Manual

4-3-l Disassembly of Engine:

(Removal of Driven Pulley Assy)

4. Removal of Driven Pulley Assy:
A. Remove Nut of Clutch
Housing with pneumatic wrench
or stop tool as shown. special
Tool: GA5000051F04.
B. Remove the Clutch Housing.
C. Remove the Driven Pulley
Assy.
D. Apply Special tool to prohibit
the rotation of Clutch Assy.
Warning
¡ ·
It is not allowed to release
the
nut quickly because the
components will fly out and
cause injury. Release lightly
will be enough.
special Tool: GA5000051F04.
E. Press tightly the both sides of
Clutch, unscrew and remove the
Nut.
Warning
¡ · Press tightly the Clutch Assy
while unscrewing the Nut,
so that the spring will not
jump out. Release slowly
after the nut is removed.
F. Remove the Clutch Assy.
G. Remove the Spring.
H. Remove the Spring Sheet
by screw driver or by hand.
I. Remove the Guide Pin.
J. Remove the Fixed Driven Face
Assy.
K. Remove the Needle Bearing.
L. Remove the C-type Snap Ring.
46