Assembly Of Movable Driven Pulley Assy - TGB Hornet 50 Service Manual

4-3-3 Assembly of Engine :
10. Assembly of Movable Driven Pulley
Assy :
A. Install the ball bearing(I)
into the fixed driven face
comp(2).
¡ · The outer diameter of bearing
press fitted with the hole
of face comp.
Pay attention to press to the
outer ring by special tool.
B. Install C-type cir-clip(3).
C. Install the needle roller
bearing(4) .
D. Apply grease (GA50400003) on
the lip of oil seal (5) and
press in the movable driven
face comp (6), one for top
and bottom each.
E. Install the fixed driven face
comp(2).into the movable
driven face comp(6).
¡ ·
Avoid damage to the lip of
oil seal.
F. Install three roller guide
pins(7).
G. Install two O-rings (8) .
H. Apply about 5g of grease
(GA50400005) to the groove of
the Cam.
I. Apply a little grease
(GA50400005) to the inside of
spring sheet and manually push
the spring sheet in lightly.
J. Install the spring .
K Press the clutch shoe assy
with both hands, and then
screwing the nut (9) with one
hand still pressing the clutch
shoe assy .
L .Use tool to tighten the nut of
clutch shoe assy.
Screw Torque: 400~600 kg . cm
Special Tool: GA5000051F04
67