Automatic Transfers At Power On Without A Parameter File - Omron CJ - 09-2009 Operation Manual

Programmable controllers

Table of Contents

CJ1-H/CJ1M CPU Unit Ver. 2.0 Upgrades

CPU Unit Ver. 2.0 or Later and CX-Programmer Ver. 4.0 or Higher

Automatic Transfers at Power ON without a Parameter File

Previous CPU Units (Pre-Ver. 2.0 CPU Units)

When using CX-Programmer Ver.4.0 or higher with CPU Unit Ver. 2.0 or later,

the first address can be set for up to 64 slots.

Note This function is supported only for CS1-H, CJ1-H, and CJ1M CPU Units

Ver. 2.0 or later. It is not supported for CS1D CPU Units for Duplex-CPU Sys-

CX-Programmer

Ver. 4.0 or higher

CPU Unit Ver. 2.0

CPU Rack slot

Previously with the CS/CJ-series CPU Units, both the program file for auto-

matic transfer at power ON (AUTOEXEC.OBJ) and the parameter file for auto-

matic transfer at power ON (AUTOEXEC.STD) had to be stored on the

Memory Card to enable automatic transfers to the CPU Unit at power ON.

Also, the parameter file for automatic transfer at power ON (AUTOEXEC.STD)

could not be created without the actual PLC (regardless of whether it was

made in online operations from the CX-Programmer or a Programming Con-

sole or by using the easy backup operation).

Even if a program file (.OBJ) was created offline without the actual PLC and

then sent to a remote PLC as an email attachment, the program file could not

be transferred to the CPU Unit without a Programming Device.

First slot addresses

Up to 64 settings

can be made.

Table of Contents