Igmp Proxy Commands - Dell N1100-ON Reference Manual

IGMP Proxy Commands

Dell EMC Networking N3000/N3100/N4000 Series Switches
IGMP Proxy is used by the router on IPv4 systems to enable the system to
issue IGMP host messages on behalf of hosts that the system discovered
through standard IGMP router interfaces, thus acting as proxy to all its hosts
residing on its router interfaces.
Dell EMC Networking supports IGMP Version 3, Version 2 and Version 1.
Version 3 adds support for source filtering [SSM] is interoperable with
Versions 1 and 2. Version 2 enhances group membership terminations to be
quickly reported to overcome leave latency and is interoperable with IGMP
Version 1.
Commands in this Section
This section explains the following commands:
arp
ip igmp proxy-service reset-status
ip igmp proxy-service unsolicit-rprt-
interval
show ip igmp proxy-service
ip igmp proxy-service
Use the ip igmp proxy-service command in Interface Configuration mode to
enable the IGMP Proxy on the VLAN interface. Use this command to enable
the sending of IGMP messages received on interfaces configured with the ip
igmp mroute-proxy command to an attached multicast router.
IGMP is enabled with IGMP proxy. Only one interface can be configured with
the IGMP proxy service. This interface forwards IGMP reports to a multicast
router on behalf of IGMP clients configured with the ip igmp mroute-proxy
command.
Syntax
ip igmp proxy-service
show ip igmp proxy-service interface
show ip igmp-proxy groups
show ip igmp proxy-service groups detail
–
Layer 3 Routing Commands
1436