Ip Routing - Dell N1100-ON Reference Manual

Example
The following example sets the default route metric to 80.
console(config)#ip route distance 80

ip routing

Use the ip routing command in Global Configuration mode to globally
enable IPv4 routing on the router. To disable IPv4 routing globally, use the no
form of the command.
Syntax
ip routing
no ip routing
Default Configuration
Disabled is the default configuration.
Command Mode
Global Configuration mode, Virtual Router Configuration mode
User Guidelines
Use the show ip brief command to determine if routing is enabled or disabled.
When in virtual router configuration mode, this command operates within
the context of the virtual router instance. When in global config mode, the
command operates on the global router instance.
Enable IPv4 routing on a VLAN by entering interface vlan mode for the
desired VLAN and assigning an IP address to the VLAN. Use the no interface
vlan command to disable routing on an interface. Ensure that statically
assigned addresses do not conflict with any configured subnets. Subnet
overlap is not allowed.
Virtual Router Configuration mode is only available on the
N3000/N3100/N4000 switches.
Example
The following example enables IPv4 routing for VLAN 15
1477
Layer 3 Routing Commands