Match Ip Address - Dell N1100-ON Reference Manual

match ip address

Use this command to specify IP address match criteria for a route map. Use
the no form of this command to delete a match statement from a route map.
Syntax
match ip address access-list-name [access-list-name]
no match ip address [access-list-name]
•
access-list-name
name can be up to 31 characters in length.
Default Configuration
There is no default configuration for this command.
Command Mode
Route Map Configuration mode
User Guidelines
The IP ACL must be configured before it can be linked to a route-map.
Specifying an unconfigured IP ACL causes an error. Actions present in an IP
ACL configuration are applied along with other actions present in route-map.
When IP ACL referenced by a route-map is removed or rules are added or
deleted from that ACL, the configuration is rejected.
Actions in the IP ACL configuration are applied with other actions present in
the route-map. If an IP ACL referenced by a route-map is removed or rules
are added or deleted from the ACL, the configuration is rejected.
If a list of IP access lists is specified in this command and a packet matches at
least one of these access list match criteria, the corresponding set of actions in
the route map are applied to the packet. Duplicate IP access list names are
ignored.
It is strongly recommended that access lists used in a route map not be re-
used for normal access list processing. This is because:
• ACLs inherit the priority of the route map. This overrides the priority of
the including access group.
—
The access-list name that identifies the named IP ACLs. The
Layer 3 Routing Commands
1481