Show Ip Route - Dell N1100-ON Reference Manual

Prefix List Out....................... PfxList3
Route Map In.......................... rmapUp
Route Map Out......................... rmapDown
172.20.5.1
Prefix List Out....................... PfxList12
Routing Protocol.......................... OSPFv2
Router ID................................. 6.6.6.6
OSPF Admin Mode........................... Enable
Maximum Paths............................. 32
Routing for Networks...................... 172.24.0.0 0.0.255.255 area 0
Distance.................................. Intra 110 Inter 110 Ext 110
Default Route Advertise................... Disabled
Always.................................... FALSE
Metric.................................... Not configured
Metric Type............................... External Type 2
Redist
Source Metric
--------- -------
static default
connected 10
Number of Active Areas.................... 3 (3 normal, 0 stub, 0 nssa)
ABR Status................................ Yes
ASBR Status............................... Yes
Routing Protocol.......................... RIP
RIP Admin Mode............................ Enable
Split Horizon Mode........................ Simple
Default Metric............................ Not configured
Default Route Advertise................... Disable
Distance.................................. 120
Interface
---------
0/25

show ip route

Use the show ip route command to display the current state of the routing
table. The output of the command also displays the IPv4 address of the
default gateway and the default route associated with the gateway.
This command deprecates the show ip route connected command.
Metric Type
-----------
2
2
Send Recv
---- ----
RIPv2 RIPv2
10.0.0.0 0.255.255.255 area 1
192.168.75.0 0.0.0.255 area 2
Subnets Dist List
------- ---------
Yes None
Yes
Layer 3 Routing Commands
1
1498