Table of Contents
Advertisement
Default Configuration
600 is the default value for seconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
The minimum interval cannot be larger than 75% of the maximum interval.
Example
The following example sets the transmission interval between router
advertisements at 1000 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ra-interval 1000
ipv6 nd ra-lifetime
Use the ipv6 nd ra-lifetime command in Interface Configuration mode to set
the value that is placed in the Router Lifetime field of the router
advertisements sent from the interface.
Syntax
ipv6 nd ra-lifetime seconds
no ipv6 nd ra-lifetime
•
seconds — Lifetime duration. The value must be zero, or it must be an
integer between the value of the router advertisement transmission
interval and 9000 seconds. A value of zero means this router is not to be
used as the default router. (Range: 0-9000)
Default Configuration
1800 is the default value for seconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
Layer 3 Routing Commands
1533
Advertisement
Table of Contents
