Cisco ASR 9000 Series Command Reference Manual page 1078

show controllers t3
Field
Status
Sync Detected
Interval
Time Remain
Bit Errors (since BERT started)
Bits Received (since BERT started)
Bit Errors (since last sync)
Bits Received (since last sync)
The following example shows sample output from the show controllers t3 command using the tabular
keyword, for a single T3 port:
RP/0/RSP0/CPU0:router# show controllers 0/4/2/0/1 tabular
T3 0/4/2/0/1 is up
INTERVAL
09:00-09:02
08:45-09:00
08:30-08:45
08:15-08:30
08:00-08:15
07:45-08:00
07:30-07:45
.
.
.
The following example shows sample output from the show controllers t3 command for a single T3 port:
RP/0/RSP0/CPU0:router# show controllers t3 0/4/2/0/1
T3 0/4/2/0/1 is up
No alarms detected.
mode: serial
MDL transmission is disabled
EIC: , LIC: , FIC: , UNIT:
Path FI:
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1058
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
LCV PCV CCV PES PSES
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
Description
Indicates the current synchronization state (sync).
Indicates the number of times synchronization has
been detected during this test.
Indicates the length of the test.
Indicates the time remaining for the test to run.
Note If you terminate a BER test, you receive a
message similar to the following: Time
Remain : 2 minute(s) (unable to complete)
"(Unable to complete)" signifies that you
interrupted the test.
Bit errors that have been detected since the test
started.
Total number of test bits that have been received since
the test started.
Bit errors that have been detected since the
synchronization started.
Total number of test bits that have been received since
the synchronization started.
SEFS UAS LES CES
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
CSES
0 0
0 0
0 0
0 0
0 0
0 0
0 0