Datalogic MAGELLAN 9800i Product Reference Manual page 76

Table 1. Error Code Table
Health &
Probable Cause
Status
Indicator
Configuration Error
Host Interface
Main Board
Reserved
ScaleSentry Error
Interface Board
Scale
Remote Display
Sensormatic Interface
Control Panel
USB Device
Scale Calibration
CPLD
USB Host
Scale Configuration
66
Corrective Action
Make sure the correct interface is selected, then scan the factory defaults
bar code and reset the unit. Also, see
details about configuring the scanner using programming bar codes.
Unplug unit and call technical support personnel.
Chapter 7, Programming, for details about configuring the scan-
See
ner for this optional feature, which may not have been purchased for your
scanner.
Unplug unit and call technical support personnel.
Scale Error Reporting on page 67
See the topic
problem identification and corrective actions.
Connect the Remote Display. If necessary, replace display or cable. Alterna-
tively, you can disable the Remote Display using the programming proce-
Chapter 7,
dures described in
No EAS communication. Check EAS cable connections and power to the EAS
controller. Call technical support personnel.
Call technical support personnel.
Proceed to scale calibration procedure.
Call technical support personnel.
Try resetting the scanner. If the problem persists, unplug the unit and call
technical support personnel.
Scale Error Reporting on page 67
See the topic
problem identification and corrective actions.
Chapter 7, Programming, for
in this section for
Programming.
in this section for
Magellan™ 9800i Scanner