Standard 2 Of 5 Check Character Transmission - Datalogic MAGELLAN 9800i Product Reference Manual

Standard 2 of 5 Check Character Transmission

Enables/disables transmission of an optional Standard 2 of 5 check character.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
049B01(CR)
Standard 2 of 5 Check Character Transmission = Enable
Product Reference Guide
This feature applies only when Standard 2 of 5 Check
Character Calculation on page 358 is enabled. This item
is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
Enter/Exit Programming Mode
049B00(CR)
Standard 2 of 5 Check Character Transmission = Disable
DEFAULT
359