Enter/Exit Programming Mode
Codabar Check Character Transmission
Enables/disables transmission of an optional Codabar check character.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
008C01(CR)
Codabar Check Character Transmission = Enable
332
Applies only when Codabar Check Character Calculation is
enabled. This item is ignored when the advanced feature,
Full Label Edit, is enabled.
NOTE
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode bar code.
008C00(CR)
Codabar Check Character Transmission = Disable
DEFAULT
Magellan™ 9800i Scanner
Codabar Enable