Scanner Control Button - Datalogic MAGELLAN 9800i Product Reference Manual

Scanner Control Button

The Scanner Control Button (item #8 in
tions depending upon the duration of time it is pressed:
NOTE
PRESS
DURATION
Momentary
(when scanner is
asleep)
Momentary
(when scanner is
awake)
1 second
5 to 9 Seconds
10 Seconds
a. Users should not perform scanner resets except under the direction of trained systems sup-
396
Volume changes made using the Scanner Control Button
are lost when the scanner is powered-down and are reset
to the factory default setting. If you wish to permanently
change the volume, use the special programming labels in
the Programming on page 91 section.
FUNCTION
Wakes scanner from
Sleep Mode
Increments volume
Increments tone
Changes good read beep
tone
Resets Scanner
reset)
port personnel.
Figure 49) also performs multiple func-
COMMENT
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- A weight change on the scale.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase
speaker volume. When the loudest volume is
reached, a repeated press of the push button
cycles volume back to the lowest setting, then
volume increases on subsequent press(es).
Five volume levels are available.
Press the push button for 1 second to change
speaker volume.
Press and hold the push button for 5 to 9 sec-
onds to change good read beep tone.
a
Only system support personnel should perform
(soft
a reset.
Magellan™ 9800i Scanner