Enter/Exit Programming Mode
MSI Check Character Transmission
Enables/disables transmission of optional MSI check characters.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
00BE01(CR)
MSI Check Character Transmission = Enable
350
This feature applies only when MSI Check Character Cal-
culation on page 348 is enabled. This item is ignored
when the advanced feature, Full Label Edit, is enabled.
NOTE
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode bar code.
00BE00(CR)
MSI Check Character Transmission = Disable
DEFAULT
Magellan™ 9800i Scanner
MSI Enable