Datalogic MAGELLAN 9800i Product Reference Manual page 46

Site Preparation and Installation
AC/DC Adapter
Figure 15
90ACC0078).
Figure 15. Physical Measurements: AC/DC Adapter
Grounding
The AC/DC Power Supply should have an AC outlet with a clean earth ground. If
you are not sure how to verify the amount of electrical noise (interference) on
the power line, ask a qualified electrician to measure the input line voltage.
3.2
Follow these steps to ensure that your unit has arrived undamaged and is fully
functional before installing it in the counter and connecting it to your POS sys-
tem.
1. Place the unit on the checkstand next to the counter cutout.
2. Route the cables up through the cutout and connect the scanner and scale
If you have a scanner with no scale, there will be only one interface cable to the
POS terminal.
3. Connect the power cord to the scanner and route the other end down
4. OPTIONAL — Route your EAS antenna cable down through the checkstand
NOTE
36
provides physical dimensions for the AC/DC Adapter (part number
2.9 cm
(1.14")
Connect cables
interface cable(s), and Remote Scale Display cable (optional) to the scan-
ner. Some POS terminals require two interface cables; one for the scanner
interface and one for the scale interface. Refer to
nection locations.
through the checkstand to the AC power outlet. DO NOT plug the power
cord in at this time.
cutout. (Reference your EAS controller's set-up instructions for proper EAS
antenna installation.)
Some cables are color-coded to indicate the location to which they
should be connected.
4.2 cm
(1.65")
10.3 cm
(4.01")
Figure 16 for cable con-
Magellan™ 9800i Scanner