Code 128 Length 2
If Code 128 Length Control is set to Fixed-Length decoding, this feature speci-
fies Code 128 second fixed length. If Code 128 Length Control is set to Vari-
able-Length decoding, this feature specifies the maximum label length.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the barcode,
to cover any unused barcodes on this and the facing page to ensure that
the scanner reads only the barcode you intend to scan.
3. Scan the appropriate digits from the
that represent the desired label length. The selectable range for this
option is 01 to 80. Pad all single digit numbers with a leading zero to yield
a two-digit entry (01-80).
4. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DEFAULT
Product Reference Guide
When in Fixed Length mode, if Length 2 is set to the value
of 00 (zero), then only Length 1 will apply.
NOTE
Set Code 128 Length 2 on page 315
Enter/Exit Programming Mode
Keypad on page 403
04B9(CR)
Set Code 128 Length 2
Default setting for this feature = 80
below. You'll need
in
Appendix C
315