Datalogic MAGELLAN 9800i Product Reference Manual page 174

NOTE
NOTE
To select the desired interface:
CAUTION
NOTE
1. Disconnect current interface cable(s) if currently connected.
2. Scan the Enter/Exit Programming Mode bar code.
3. Scan the bar code representing the appropriate interface located on the
following pages. You'll need to cover any unused bar codes adjacent to
and on any facing pages to ensure the scanner reads only the bar code you
intend to scan.
4. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
5. Connect new interface cable(s).
164
A new scanner may have been shipped from the factory with a
Null Interface (no interface type selected) to ensure system
compatibility at installation. In this case, the correct Interface
Type programming bar code must be scanned first before the
scanner can be used with a POS system.
If the scanner's interface type must be changed, always be sure
that interface configuration is the FIRST item scanned during a
programming session. (Selecting an interface type resets ALL
other configuration items to the factory default for that inter-
face type.)
Great care should be taken to select the correct interface type,
since you can cause damage to the scanner and/or POS termi-
nal by attempting to change to an incompatible interface.
ALWAYS make interface selections with the host cable DIS-
CONNECTED.
When an interface is selected, the scanner loads the configura-
tion for that interface as the selection is made. Any custom
configurations done in the previous interface will not be carried
over to the configuration for the new interface.
Once the correct interface has been set, it will be necessary to
proceed to the appropriate pages in this manual that select
parameters and options for that interface. For example, if RS-
232 is selected, turn to the pages in this manual headed as
features specific to the RS-232 interface.
Magellan™ 9800i Scanner