Datalogic MAGELLAN 9800i Product Reference Manual page 54

Site Preparation and Installation
1. Remove the All Weighs™ Platter to gain access to the lift handles. Lift the
Figure 20. Removing the All Weighs™ Platter
2. The scanner provides lift handles that must be rotated up into position for
Figure 21. Using the Lift Handles
3. Lower the unit into the counter opening, ensuring that none of the cables
4. View the bubble level (if present
1. The bubble level is present only on certain models.
44
top edge of the platter bezel as shown in
the scanner. If the top edge of the platter is blocked, you may find it easier
to grasp edges of the platter as shown by the blue arrows.
use as shown in Figure
allowed to rotate back down into their seated positions in the cavity. Use
reasonable care when attempting to lift the unit using any features other
than the lift handles.
Bubble Level
are pinched, pierced or crimped.
bly to ensure the scanner is level. As shown in the insert of
Figure 20
21. When released, these handles should be
1
) located on the scanner's spider assem-
and gently lift it from
Figure 20, the
Magellan™ 9800i Scanner