Sensormatic Eas Button; Camera Button; Mobile Commerce Button - Datalogic MAGELLAN 9800i Product Reference Manual

Sensormatic EAS Button

The Sensormatic EAS Button has configurable functions. Use the
on page 91
when the scanner is enabled.
PRESS
DURATION
a
Momentary
3 Seconds upon
EAS error
a. For use in Coupled Mode only
b. "Downstream" in this case is defined as being the downstream side of the scan window from the direc-
tion of product flow, or scanning direction.
c. If the EAS failure corrects itself, blinking will stop and the EAS LED will turn green.

Camera Button

The Camera Button (see
PRESS
DURATION
1st Momentary Press
2nd Momentary Press

Mobile Commerce Button

With a momentary press, the Mobile Commerce Button
and out of Mobile Commerce mode.
Product Reference Guide
section to configure the button to operate always, or only function
FUNCTION
Manually initiates EAS
deactivation
Allows scanner to
resume function despite
EAS system failure (non-
fatal error)
Figure
FUNCTION
Enables the Camera
Function
Captures Image
COMMENT
Place the item with the EAS tag downstream
zontal scan window and push the button.
EAS Failure Mode is indicated
- EAS LED blinks ON/OFF red, scanning disabled.
- FRU Status LED Indicator blinks '9'
- Error tone is sounded for one second
Upon pressing the button for 3 seconds, the scanner
will sound 3 high-pitched beeps, then resume scan
function. The EAS LED and FRU Status LED will con-
tinue blinking as above, but at a slower rate until EAS
system function is restored.
49) is used for multiple functions as listed.
COMMENT
Enables image capture mode for the unit.
Once in image capture mode, the second press
captures the image.
Controls and Indicators
Programming
b
of the hori-
c
by:
(Figure 49) goes into
395