Datalogic MAGELLAN 9800i Product Reference Manual page 56

Site Preparation and Installation
Figure 22. Modular/Adjustable Remote Scale Display
Remote Display Cabling
Your installation should also take into account the routing of Remote Display
cabling. Ensure that distance and obstacles spanned by the routed cable will
not kink, pinch or stretch it. Also keep in mind you may need to drill a hole
through which to route it.
Placing and Installing the Remote Display
1. Determine where you want to install the Remote Scale Display based on
2. Use the template provided in
•
3. Drill the mounting screw holes using a drill bit of the appropriate diameter
4. Drill the cable routing hole using a 19 mm (
46
Dual Display
Heads
Single Display
Head
your counter design, the viewing angle, lighting considerations and cable
routing discussed previously. Reference
cal dimensions. Optimally, the display(s) should be approximately eye
level to the viewer(s).
screw and cable routing holes.
The mounting screw holes are on 8.5 cm (3.5") centers. The cable can
either be routed through a 8.51cm (3.35") diameter hole directly under the
mounting base or through the cutout in the back of the base.
for your mounting screws or bolts.
Rotation
Figure 23
Figure 25 to mark locations of the mounting
¾
") drill bit (optional).
15° 15°
15°
Upward or
Downward Tilt
180°
Rotation
180°
for the display's physi-
Magellan™ 9800i Scanner