Site Preparation and Installation
Depending upon the model, steps to install will vary slightly.
1. Determine on which corner of the scanner you want to install the TDR. It
2. For 7" or 12" models, gently slide the Filler Tab from the Corner
3. Route the TDR cable down through the Riser if present [only on 9" model]
32
can be placed in either the left or right-hand corner just behind the scan-
ner's bonnet. Carefully push upwards on the plastic Corner Piece to disen-
gage it from the scanner.
will leave an opening for the neck of the TDR. [For the 9" model, use the
new Corner Piece provided.]
Filler Tab
Corner Piece
and the base of the
scanner, gently pulling it all the way through on the
bulkhead side of the base and seating the TDR in its corner cavity. Make
sure it is not pinched or caught beneath the scanner base.
Corner Piece
Corner Piece for 9" TDR
Magellan™ 9800i Scanner
Piece. This