Enter/Exit Programming Mode
I 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Interleaved 2 of 5 check charac-
ter.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
008B01(CR)
I 2 of 5 Check Character Transmission = Enable
320
This feature applies only when I 2 of 5 Check Character Cal-
culation is enabled. This item is ignored when the
advanced feature, Full Label Edit, is enabled.
NOTE
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode bar code.
Interleaved 2 of 5 (I 2 OF 5) Enable
008B00(CR)
I 2 of 5 Check Character Transmission = Disable
DEFAULT
Magellan™ 9800i Scanner