Radwin 5000 HPMP User Manual page 91

Configuring the Sector out of the Box - IP Addresses
Figure 5-2: Logging on with Local Connection
Warning
Here is the initial main display using Local Connection:
RADWIN 5000 HPMP User Manual
• The Local Connection method uses broadcast packets to "discover"
the attached ODU
• If you log on using Local Connection, but your physical connection
is not local (i.e. anything other than a direct connection between the
managing computer and the PoE device), then any configuration you
carry out may affect other links in the network. Do not do this!
• Do not carry out this procedure using a multi homed managing com-
puter also connected to a network. It will flood the network with
broadcast packets. Further, it will throw any other links on the net-
work into Installation or Inactive mode.
• In any event, as a precaution, default log-on over Local Connection is
read-only mode. Check the Read/Write enable box to carry out instal-
lation procedures.
• Network log on (IP address to the ODU) is recommended.
Release 3.3.30
Chapter 5
5-7