Radwin 5000 HPMP User Manual page 346

MIB Traps
Table C-2: Private MIB Parameters (Sheet 24 of 24)
Name
winlink1000HsuAirLocalDeregister
winlink1000HsuAirRemoteCompressedMon
winlink1000HsuAirRemoteCompressedStatic
winlink1000HsuAirRssThreshSync
winlink1000HsuServiceCommandStr
winlink1000HsuServiceHsuType
winlink1000HsuServiceHsuLevel
winlink1000HsuEthernetPoESupported
winlink1000HsuEthernetPoETemperature
winlink1000HsuEthernetPoEEquConsumption
winlink1000HsuEthernetPoEEquVoltage
winlink1000GeneralTrapDescription
winlink1000GeneralTrapSeverity
winlink1000GeneralCookie
winlink1000GeneralEcChangesCounter
winlink1000GeneralTelnetSupport
winlink1000GeneralWISupport
MIB Traps
General
Each ODU can be configured with up to 10 different trap destinations. When the link is oper-
ational, each ODU sends traps originating from both Site A and Site B.
RADWIN 5000 HPMP User Manual
OID
1.3.6.1.4.1.4458.1000.100.1
1.3.6.1.4.1.4458.1000.100.2
1.3.6.1.4.1.4458.1000.100.3
1.3.6.1.4.1.4458.1000.100.4
1.3.6.1.4.1.4458.1000.100.5
1.3.6.1.4.1.4458.1000.100.6
Release 3.3.30
Type Description
RW Performs Local HSU Deregistration when - only
when the link is off.
RO Holds all the configuration data of The HBS in
compressed format.
byte)
bytes) In Bytes of the whole sector (4 bytes)
Out Bytes of the whole sector (4 bytes)
Frames of the whole sector (4 bytes)
Frames of the whole sector (4 bytes) Max
Throughput DownLink (4 bytes) Max Throughput
UpLink (4 bytes) Rx Rate In Kbps of the whole
sector (4 bytes) Tx Rate In Kbps of the whole
sector (4 bytes) Rx Rate In Fps of the whole sector
(4 bytes) Tx Rate In Fps of the whole sector (4
bytes)
RO Holds all the configuration data of the HBS in a
compressed format. Helps the NMS to get info
regarding new Unregistered links. Fields Included:
Location (32 bytes) IP address (8 bytes in 4458)
Subnet mask (8 bytes in 4458) HBS Antenna
type (1 byte) HBS Agent Version (4 bytes)
RW HSUs will be synchronized immediately if RSS is
better than threshold.
RW Ability to perform special command in the HSU.
Format (string): Operation Param1 Param2 ....|
ParamN.
RW HSU type (1 = Fixed 2 = Stationary 3 = Mobile)
RW HSU level (1 .. 4)
RO
RO Holds the temperature (Celsius) of the POE
component.
RO Holds the consumption of the connected equipment
(milliampere).
RO Holds the voltage of the connected equipment
(Volt).
DisplayString RO Trap's Description. Used for Trap parameters.
Integer RO Trap's Severity. Used for Trap parameters.
DisplayString RW Reserved for the Manager application provided with
the product used for saving user preferences
affecting ODU operation.
Integer RO This counter is initialized to 0 after a device reset
and is incremented upon each element constant
write operation via SNMP or Telnet.
Integer RW Enable/Disable Telnet protocol.
Integer RW Enable/Disable Web Interface protocol.
Mandatory Disabled - No option to enable the
feature.
disable the feature.
Appendix C
Fields Included: Rss (1
Rss Balance (1 byte) Est. Tput (4
Mandatory Enabled - No option to
C-28
In
Out