Radwin 5000 HPMP User Manual page 255

Setting up an HSU for QoS
3. Ensure that the Mode field is Enabled. If you already configured the HBS (sector) for
Diffserv or VLAN, then it will be enabled by default. If you need to change the mode,
then you probably did not set the sector wide QoS type - but you can go back and do
it later.
4. For each queue, both downlink and uplink (from the HSU) enter the required weight
and MIR. The latter may be left unlimited. in which case the system will use a "best
effort" method.
If you exceed 100% total weight, you will receive an error message.
You will be required to correct this before leaving the window other than by cancella-
tion.
If you are under-booked, for example by setting a queue to zero, the unused weight
will be distributed to the remaining queues. The effect of doing this will only become
apparent under congestion. In particular, a queue set to zero weight will become
nearly blocked under congestion with packets passing through on a best effort basis.
5. When you complete your entries, click OK to save them and continue.
RADWIN 5000 HPMP User Manual Release 3.3.30
Chapter 16
16-4