Radwin 5000 HPMP User Manual page 166

Telnet Access to the HSU
Telnet Access to the HSU
The procedure is the same as for the HBS.
Figure 6-22: Telnet Management window - HSU
Supported HSU Telnet commands are shown in
Table 6-4: HSU Telnet - Display Commands
Command
display inventory
display management
display link
display ethernet
display ethernet_errors
display ntp
display PM <interface:AIR,LAN1>
<interval:current,day,month>
display bands
Table 6-5: HSU Telnet - Set Immediate Commands
Command
set ip <ipaddr> <subnetMask> <gateway>
set trap <index:1-10> <ipaddr> <port:0-
65535>
set readpw <oldpasswd> <passwd>
RADWIN 5000 HPMP User Manual
Table 6-4 to
Explanation
Displays ODU product name, Name, Location, hardware and software
revisions, uptime, MAC address.
Displays IP, subnet, Gateway, Traps table
Displays all static details about the HSU
Displays Port table (State, Status and action)
Displays Cable statistics
Displays Time, Server and Offset
Shows the performance monitor tables for each interface according to
user defined monitoring intervals
Displays available bands
Explanation
Set the ODU IP address, subnet mask and gateway. The user must reset
the ODU after the command completion
Set a specific trap from the traps table (e.g. set trap 3 192.168..101 162)
Set the read access password (Read Community)
Release 3.3.30
Chapter 6
Table 6-6.
6-46