Radwin 5000 HPMP User Manual page 217

Preparing the GSU for Use
Figure 11-5: General GSU configuration
In that respect, all of the considerations of
use Manual apply to the GSU.
It may be configured using the regular RADWIN Manager or Telnet.
Preparing the GSU for Use
Log on to the unit using the default IP address, 10.0.0.120 or Local Connection (See the cau-
tions in Chapter 5 about using Local Connection). Use Site Configuration and then the Man-
agement tab as shown on
and then disconnect the unit for transportation to its site.
Mounting the GSU
Mount the GSU and antenna. Ensure that its ODU port connected to its PoE device and the
HSS cable is connected to the HSS unit as shown. The external LAN port of the PoE device is
connected to the managing computer. If you are accessing the GSU through a network it is
essential that you use the IP pre-loading method. The default IP address may be inaccessible
and you may not use the Local Connection method over a network.
Configuring the GSU
Getting Started
To configure the GSU, you log on to it, exactly as in
The GSU Main Window
Here is the main window for GSU configuration:
RADWIN 5000 HPMP User Manual
Chapter
page 11-11 below. Enter the required IP information, click OK
Release 3.3.30
3, Chapter 17 and
Chapter 5.
Chapter 11
Chapter 18 of the
11-5