Mib Parameters; Figure C-2 Product Mib - Radwin 5000 HPMP User Manual

MIB Parameters

The products MIB section contains the definition of the Object IDs for the two form factors of
the ODUs, Integrated Antenna and Connectorized (referred in the MIB as external
antenna) and GSU (where applicable):
Figure C-2: Product MIB
The GpsSynchronizerFamily MIB defines the GSU.
The general MIB include a single generic parameter that is used by all traps as a trap descrip-
tion parameter.
MIB Parameters
The following section describes all of the MIB parameters. The MIB parameters follow the fol-
lowing naming convention:
<winlink1000><Section 1>...<Section n><Parameter Name>
For each of the configuration and control parameters (parameters with read-write access),
the "Description" column describes when the new value is effective. It is recommended that
you perform the appropriate action to make the values affective immediately after any
change. Where a change is required on both sides of the link, it is recommended that you
change both sides of the link first and then perform the action.
Supported Variables from the RFC 1213 MIB
Table C-1: Supported RFC 1213 Variables (Sheet 1 of 2)
Name
ifIndex
ifDescr
ifType
RADWIN 5000 HPMP User Manual
OID
a
.1.3.6.1.2.1.2.2.1.1.x
.1.3.6.1.2.1.2.2.1.2
.1.3.6.1.2.1.2.2.1.3
Release 3.3.30
Type Description
Integer RO A unique value for each interface.Its value ranges
between 1 and the value of ifNumber.The value for
each interface must remain constant at least from
one re-initialization of the entity's network
management system to the next re-initialization.
DisplayString RO A textual string containing information about the
interface.This string should include the name of
the manufacturer, the product name and the
version of the hardware interface.
Integer RO The type of interface, distinguished according to
the physical/link protocol(s) immediately `below'
the network layer in the protocol stack.
Appendix C
C-3