Radwin 5000 HPMP User Manual page 339

Private MIB Parameters
Table C-2: Private MIB Parameters (Sheet 17 of 24)
Name
winlink1000IduSrvTrunkCost
winlink1000IduSrvAvailServicesTable
winlink1000IduSrvAvailServicesEntry
winlink1000IduSrvAvailServicesIndex
winlink1000IduSrvAvailServicesState
winlink1000IduSrvAvailServicesMinRateIdx
winlink1000IduSrvAvailServicesMaxRateIdx
winlink1000IduSrvAvailServicesReason
winlink1000IduSrvEthActive
winlink1000IduSrvEthAvailable
winlink1000IduSrvEthThroughput
winlink1000IduSrvEthMaxInfoRate
winlink1000IduSrvAvailableTrunksT1
winlink1000IduEthernetIfTable
winlink1000IduEthernetIfEntry
winlink1000IduEthernetIfIndex
winlink1000IduEthernetIfAddress
winlink1000IduEthernetNumOfLanPorts
winlink1000IduEthernetNumOfSfpPorts
winlink1000IduEthernetSfpProperties
winlink1000IduEthernetGbeSupported
winlink1000IduEthernetOduInErrors
winlink1000IduBridgeTpAging
winlink1000IduTdmTxClockAvailStates
RADWIN 5000 HPMP User Manual
OID
Release 3.3.30
Type Description
RO Cost of the TDM Service in bps.
N/A ODU Possible TDM Services table.
N/A ODU TDM Services table entry. INDEX {
winlink1000IduSrvAvailServicesIndex }
RO Table index. The index is the bit mask of the TDM
service.
RO Represents the TDM service availability.
RO Minimum rate index of the air interface which make
the service possible.
RO Maximum rate index of the air interface which make
the service possible.
RO Information about the TDM Service availability.
Not Applicable if the service is available.
reasons for TDM Service unavailability:
available throughput isn't sufficient for Service
demands;
service;
detected;
improper for TDM services;
mismatch was detected.
Is Obligated.
RO Represents the Ethernet service activation state.
RO Represents the Ethernet service availability state.
RO Current available Ethernet service throughput in
bps.
RW Holds the maximum bandwidth (kbps) to be
allocated for Ethernet service.
means that Ethernet service works as best effort.
The maximum value is product specific. Refer to the
user manual.
RO A bitmap describing the TDM trunks that can be
opened under T1 configuration.
into account the IDU hardware configuration the air
rate and the installation range.
N/A IDU Ethernet Interface table.
N/A IDU Ethernet Interface table entry. INDEX {
winlink1000IduEthernetIfIndex }
RO If Index corresponding to this Interface.
RO IDU MAC address.
RO Number of LAN interfaces in the IDU.
RO The number of SFP interfaces in the IDU.
RO SFP venfor properties : Vendor Name PN and
Revision.
RO
RO The number of inbound packets that contained
errors preventing them from being deliverable to a
higher-layer protocol.
RW Timeout in seconds for aging. Note that for this
parameter to be effective
configured to HUB mode. A change is effective
immediately.
RO Available states of the TDM Transmit Clock Control
each input status is represented by a bit. When the
state is available the bit value is 1. When the state
is unavailable the bit
states are:
Timed bit 4 = Remote Loop Timed bit 5 = Local
Internal bit 6 = Remote Internal
Appendix C
- The IDU HW doesn't support the
- A Link Password mismatch was
- The external pulse type detected is
- A Software versions
- A-Symetric TDD Mode
Value of zero
The values take
the ODU must be
value is 0. The available
bit 2 = Transparent bit 3 = Local Loop
C-21
-
The
- The