Chapter 3 Hardware Installation; Safety Practices - Radwin 5000 HPMP User Manual

Hardware Installation
This chapter sets out the requirements and procedures for the hardware installation and
alignment of a RADWIN 5000 HPMP sector in accordance with the prior planning as set out in
Chapter 2. It is intended to guide qualified field technicians.
The material in this chapter is generic to all RADWIN radio products unless
stated otherwise.
Note
Outdoor units and antennas should be installed ONLY by experienced
installation professionals who are familiar with local building and safety
codes and, wherever applicable, are licensed by the appropriate
government regulatory authorities. Failure to do so may expose the end
user or the service provider to legal and financial liabilities. RADWIN and its
Warning
resellers or distributors are not liable for injury, damage or violation of
regulations associated with the installation of outdoor units or antennas.
When installing the SU2-AC:To maintain Overvoltage (Installation)
Category II, install a suitable surge suppressor device in the branch circuit
to limit expected transients to Overvoltage Category II values.
The limits are based on IEC60664 and are also located in Table 2H of
Warning
UL60950 (for mains ≤ 150V, the transient rating is 1500V; for 150V <
mains ≤ 300V, the transient rating is 2500V; and for 300V < mains ≤ 600V,
the transient rating is 4000V)

Safety Practices

Preventing overexposure to RF energy
To protect against overexposure to RF energy, install the ODUs so as to provide and maintain
minimal separation distances from all persons.
When the system is operational, avoid standing directly in front of the antenna. Strong RF
fields are present when the transmitter is on. The ODU must not be deployed in a location
where it is possible for people to stand or walk inadvertently in front of the antenna.
RADWIN 5000 HPMP User Manual Release 3.3.30
Chapter 3
3-1